GeoScape Integration

The GeoScape integration allows you to add address validation to your forms. This helps users search for and select the address they need, then add it directly to the form.

Configure the integration once to make it available across your forms.

TABLE OF CONTENTS

• GeoScape Key Configuration
• Setting Up the GeoScape Integration
• Adding a GeoScape Element to a Form
• Getting an Address from a Location
• Additional Configuration
• Getting Help

GeoScape Key Configuration

Before setting up the integration, ensure your GeoScape API key has both of the following products enabled:

• Predictive API
• Addresses API

Setting Up the GeoScape Integration

Step 1: Open the Integrations menu and click Setup Integration on the GeoScape integration card.

Step 2: Add your GeoScape API key, then click Save.

Adding a GeoScape Element to a Form

After the integration has been configured, you can enable GeoScape on a form and add a GeoScape element.

Step 1: Open the form you would like to configure.

Step 2: Go to the form Developer Tools tab and enable the GeoScape configuration.

Step 3: In the Builder tab, you will now be able to add GeoScape elements to the form.

Getting an Address from a Location

If your form users may not know their exact street address, you can allow them to use a Location element to set the address. This uses the GeoScape integration to reverse geocode the selected location and return the nearest address.

Step 1: Confirm that the GeoScape integration has been configured for your account.

Step 2: Add a Location element to your form.

Step 3: Add a GeoScape element for the address to be populated into.

You can also populate a Text element if preferred.

Step 4: Open the Advanced section of the Location element details.

Step 5: Turn on the Show Street Address switch.

Step 6: In the Formatted Address Element input, select the GeoScape element you want to populate.

You will now be able to populate the GeoScape Address element using the Location element.

Additional Configuration

Conditional logic can be configured so that elements are only displayed when the returned address is in specific states.

Getting Help

If you need any assistance with GeoScape Integration, please reach out through the Report Issue menu or email support@oneblink.io.